Solenoid Valve Specifications and Dimensions: 2SO160-500 and 2WO160-500 Series

2SO & 2WO Series 2/2 Direct Lift Diaphragm Normally Open Solenoid Valve:

This valve is a two-way, normally open, direct-lift valve and does not require a minimum differential pressure to operate. As shown in the diagrams below, when the coil is de-energized (left diagram), the spring force holds the diaphragm in place above the main orifice, allowing the working medium to flow freely through the valve. When the valve is energized, the diaphragm is pushed onto the main orifice, sealing the valve. The working medium supplies additional sealing pressure above the diaphram, reducing strain on the solenoid coil. This is accomplished via a small bleed orifice in the diaphragm which allows the working medium to pass through and pressurize the diaphragm from above while the valve is closed. The working medium and flow direction are indicated in purple in the diagrams.

ALL standard valves are supplied with Continuous Duty Coils of the proper class of insulation for the service indicated on the valve. It is normal for the coil temperature may become hot after being energized for extended periods. Smoke or burning odor indicates excessive coil temperature and the power should be disconnected to the coil immediately.

SERVICE LIFE: The service life of the solenoid valve depends on the operating conditions such as pressure, temperature, type of medium, and the voltage.

Electrical Coil Connections

To Connect a DIN Coil:

• Remove the Philips screw from the plastic housting & unplug from the DIN coil.
• Use the removed screw to push the terminal block out of the plastic DIN housing.
• Note the “1”, “2”, and ground “⏚” symbols.
• • • • For DC DIN Coils, connect “1” to your positive lead and “2” to your negative lead.
      • For AC DIN Coils, connect “1” to your HOT lead, “2” to your NEUTRAL lead, and “⏚” to your ground lead, if required.

To Connect a Grommet Coil:

• For DC Coils, connect the red wire to your positive lead and the black wire to your negative lead.
• For AC Coils, connect the black wire to your HOT lead and the white wire to your NEUTRAL lead.
• For Coils provided with Molded Cables, the color of the wire indicates the type of lead:
• • • GREEN = Ground Wire
    • BLUE = Positive or HOT Wire
    • BROWN = Negative or Neutral Wire